All for Joomla All for Webmasters

UHST-3 Line

UHST-3 Line - Plate Bending Machines
Standards & Advantages of UHST-3
"• High efficiency on heavy plate bending operation
• Reduced overall dimensions and easiness of transportation on medium and big machines
• Having the two bottom rolls horizontally moving, means also a lower working height which requires a smaller foundation pit and less anchoring load (in the smallest models you don’t need foundation)
• During operation (pre-bending and bending phases), the plate always keeps its horizontal position. So material move more easily
• The solid construction and the particular geometry of the UHST-3 enable to be used as a press brake bending machine
• The UHST-3 machine can fulfill the best pre-bending on every required diameter.
• The posibility to reduce centre-distance between lower rolls realizes a better pre-bending during bending of tubes with small diameter and thickness
" "• Another important feature of the UHST-3 machine is the operating system of the top forming roll. In fact, the top forming roll can be used as a traditional press brake allowing perfect rerolling and calibration operations of the produced tubes
• In the same way it is also possible to obtain cones with heavy thickness by bending in several strokes the plate
• With some 3 and 4 rolls pyramidal machines it is necessary to tilt the top roll to allow the produced tube removal. On the UHST-3 machine this is not necessary and therefore it is much more easier to remove the finished tube
• Large working stroke allows to get best bending result
• Can bend more thicker plates compare to equivalent 3 or 4 roll machines
• Induction hardened forged or rolled SAE 1050 (CK 45) Steel Rolls
• Double Speed Working system
• Conical Bending device
• Electronic balancing system
"

Email Newsletters:

UZMA, your business partner in your production

  • Address: Alaaddinbey Mah.
    646.Sok. No: 8/A
    16285 Nilüfer / Bursa / Turkey
  • Phone: +90 224 249 7735 - Office
    +90 224 249 7748 - Fax